GBC 25e - Manual (Page 13)

© 2002 IBICO Page 4-1
Operations Manual Patriot 25E
4.0 Installation
This section will guide you through the installation process
of the laminator.
INFORMATION: Shipping damage should be
brought to the immediate attention of the delivering
carrier.
4.1 Setting up the laminator
1. Place the Patriot 25E on a stable flat surface capable
of supporting at least 95 lbs. (45kgs).
The surface should be at least 30 inches high to assure
comfortable positioning during operation.
CAUTION: Too high or too low of an operating
position can lead to serious bodily injury.
All four rubber support feet should be positioned
completely on the supporting surface.
CAUTION: The laminator is a heavy piece of
equipment and may cause injury if it falls and/ or
require extensive repair work.
The supporting surface may also be large enough to hold
the material being laminating.
2. The laminator should be positioned to allow exiting
film to drop freely to the floor.
CAUTION: Accumulation of laminate immediately
behind the laminator as it exits the equipment may
cause the film to wrap around the pull rollers,
resulting in a “jammed” condition.
3. Avoid locating the laminator near sources of heat or
cold. Avoid positioning the laminator in the direct path of
forced heated or cooling air.
INFORMATION: This effects the performance of
the heating system and could result in poor output
quality.
4. Connect the attachment plug provided with the
laminator to a suitably grounded outlet only.
Refer to Section 3.4 Electrical requirements
CAUTION: Avoid connecting other equipment to the
same branch circuit to which the laminator is
connected. This may result in sporadic tripping of
circuit breaker or blowing fuses.