GBC 25e - Manual (Page 17)

© 2002 IBICO Page 5-3
Operations Manual Patriot 25E
5.2 Control panel
Refer to Figure 5.2.1
(1) POWER: This light illuminates when power to the
laminator is “ON”. If this lamp is not lit, no power to the
laminator is being supplied.
(2) HEAT: Illuminates when the laminator is first turned
on and when the laminator calls for more heat.
(3) READY: Indicates when the laminator has sufficient
heat for the selected film gauge.
(4) STANDBY: Illuminates indicating the laminator is in
“STANDBY” mode. In standby mode, the temperature
is reduced. Press this button to revert to operating mode.
The temperature will restore itself to the predetermined
film gauge setting.
(5) 1.5 & 3 MIL: This button must be pressed to set
temperature and speed settings required to for these
thicker gauge films.
(6) FAST: When pressed, increases the speed of the
laminator by overriding the preset condition.
(7) SLOW: When pressed, decreases the speed of the
laminator by overriding the preset condition.
(8) REVERSE: When pressed, reverses the roller
direction. Use this button to clear film jams and wrap-
ups.
(9) RUN: When pressed, activates rollers for normal
operation.
(10) STOP: When pressed, stops the movement of the
rollers.
Figure 5.2.1 Control panel
POWER HEAT READY
FILM GUAGE
STAND BY
1.5 & 3 MIL
REVERSE
RUN
STOP
SLOW
FAST
IBICO
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)