GBC 25e User Manual
Page 22
Operations Manual
© 2002 IBICO
Page 6-2
Patriot 25E
7.
Move the lower idler into the locked position.
8.
Pull the upper laminating film down over the upper
idler and drape over the heat rollers.
9.
Slide the feed table under the draped film from the
lower supply roll and replace the feed table ensuring the
film stays on top of the feed table. Lower the safety shield
into the fully closed position.
10.
Slide the threading card ( a piece of heavy stock
paper, card board or similar product) between the feed
table and the film resting on the feed table. Push the
threading card into the nip of the heat rollers.
11.
Tun power to ON and press RUN.
12.
Once the threading card has completely exited the
rear of the laminator, press STOP.
13.
Trim the threading card off using the rear slitter.