GunVault GV 2000 - Manual (Page 11)

- 10 -
Enroll Additional Fingerprints

Open the GunVault by administrator’s fingerprint. Immediately after the door opens press
and hold S1 button until 2 beeps sound.

Place the new finger on the Fingerprint Reader, then press S1 button to activate the module,
hold the finger on the reader until the Green light is on (it may need about 1-2 seconds).

The new fingerprint is now enrolled.
Delete All of the Fingerprint Templates

Press and hold the red S2-Delete All Button (located inside the unit on the top back portion
of the metal lock housing) and then press and release the S1 to activate the GunVault.

Continue to hold the S2 button until Green
and Red lights stop flashing, and then release the
S2 button.

Now ALL of the
fingerprints are deleted.
Internal Courtesy Light
When an access code has been used to open the safe, the interior light will shine for five seconds,
allowing a clear view of the interior.
DC Power Jack and External AC/DC Power Supply
Warning: Never attempt to operate the safe with external power alone. Batteries MUST be
installed before and during operation with the external power supply, in order to avoid
interruption of power and loss of access codes.
Any interruption of power could cause the computer memory to reset to factory settings.
Warning: Never attempt to plug in a battery charger of any kind. Fire or explosion of
batteries could result. Never use rechargeable batteries of any kind in a GunVault safe. Their
power characteristics are not compatible with the safe.
The AC/DC power supply specified is NOT a battery charger; it is an external power supply to
be used only when batteries are installed.