GunVault GV 2000 - Manual (Page 6)

- 5 -
GV 1000S/1000D and GV 2000S/2000D Models
Close the Door and Practice
SECURE YOUR KEYS!
DO NOT LOCK THEM INSIDE THE SAFE!
For practice, use the factory-default code, which is:
Press each button one time, from left to right – one,
two, three, four. (A common mistake is to press
button one once, button two twice, button three three
times, etc.) Notice the “feel” of the keypad; feel the
“click” as you press each key (One, Two, Three,
Four).
Getting Ready to Program

Find the LED light in the keypad.

It can glow either green or red. Depending upon the function being utilized.

There is an audible beep when keys are pressed.
Choosing Your Own Access Code
 Don’t tell anyone your code.

An access code is a series of entries on the keypad. WARNING: This is not a numeric
keypad, you cannot program digits (there is no 5, 6, 7, 8, 9, or 10).
 An “entry” is a single press of one or more buttons at the same time.

You can use a minimum of three entries, or a maximum of six entries, for your access code.

For each entry of the access code, you may choose one, more than one or ALL of the buttons
on the keypad in combination.
 Be careful in choosing your access code. You’ll want to be sure that you can operate the unit
quickly without making an entry error.

Example of a valid access code;
Press button one, press button
two, press all four buttons
together.

Choose an access code which is
easy to use, but try to make it an
access code which is difficult to
guess.

Your current address or phone
number digits are not good
choices, because the keypad
only has four buttons.