GunVault GV 2000 - Manual (Page 8)

- 7 -
Security Sleep Mode
The GunVault safe has a “Security Sleep Mode” that activates when 24 consecutive incorrect
entries are made (if the correct code is entered within 24 entries, the door will open). During
Sleep Mode the keypad does not accept any entries and last for two minutes. If a button is
depressed during Sleep Mode, the LED blinks red and the alarm beeps three times. The backup
key may be used to open the safe during sleep mode.
Motion Detection and Alarm Features (DLX Models Only)
Deluxe Model GunVault safes are equipped with Motion Detectors and Audio Alarms. Once
armed, this system will protect the safe and its contents if either one of the following occurs:
1. Twenty-four wrong entries are entered into the keypad in succession.
2. The safe is moved or disturbed.

If the Motion Detector is armed, shock, vibration or motion of any kind may trigger the
Audio Alarm.

If the alarm is triggered, a four second continuous tone will sound, followed by 25 short
audio ticks, indicating that the alarm is about to sound.

This pre-alarm delay will last for about ten seconds, after which the alarm will sound for one
minute.

If a valid code is entered during this period, the alarm will stop.

If the alarm is not turned off, it will enter Battery Saver Mode after two minutes. In Battery
Saver Mode the alarm will sound once per minute. Turn the alarm off at any time by
entering the access code.
Setting the Alarm:
To arm the Motion Detector Feature, press buttons one and four at the same time and hold for
more than five seconds. A beep will sound once per second for 10 seconds. The alarm feature is
now armed.
Setting the Sensitivity:
The Motion Detector has four levels of sensitivity. Level one is the MOST sensitive, and level
four is the LEAST sensitive. The factory setting is level two.

To change the sensitivity level, press and hold the Learn Button two times, for two seconds
each press. The green light will flash and a beep will be heard each time.

Press the desired sensitivity level.
1. Press button one to select the highest sensitivity
2. Press button four to select the lowest sensitivity.

The sensitivity level is now set.