GunVault GV 2000 - Manual (Page 9)

- 8 -
Turning Off the Audio Alarm:
To disable the Audio Alarm, enter a valid access code. If the alarm has already been triggered,
enter a valid access code. If an invalid access code has been entered, and the alarm is sounding,
wait a few seconds and enter a valid access code. Note: Once a valid access code has been
entered, the alarm and motion sensor are disabled. To re-enable the alarm function, follow the
instructions for setting the alarm.
Internal Courtesy Light (DLX Models Only)
When an access code has been used to open the safe, the interior light will shine for five seconds,
allowing a clear view of the interior.
DC Power Jack and External AC/DC Power Supply (DLX Models Only)
Warning: Never attempt to operate the safe with external power alone. Batteries MUST be
installed before and during operation with the external power supply, in order to avoid
interruption of power and loss of access codes.
Any interruption of power could cause the computer memory to reset to the factory code: one,
two, three, four. If this occurs, anyone who enters the one-two-three-four code will gain access
to the safe and its contents.
Warning: Never attempt to plug in a battery charger of any kind. Fire or explosion of
batteries could result. Never use rechargeable batteries of any kind in a GunVault safe. Their
power characteristics are not compatible with the safe.
The AC/DC power supply specified is NOT a battery charger; it is an external power supply to
be used only when batteries are installed.