IDX CW-7 - Manual (Page 21)

19
6. Operation guide
6.1. Set up
 The CW-7 does not include various accessories that may be used in its
operation. Please obtain each of the following items as needed for your
specific application before use.
 BNC cable for HD-SDI IN and OUT.
 IDX ENDURA batteries or external power supply
Note: Power supply; Use only an AC adaptor or batteries specified
below.
 CW-7 accepts the DC power range of 11V – 17V.
 EXT DC-IN connector is XLR-4P male,
Pin No.1: negative (-), Pin No.4: positive (+).
Note: Please do not apply over-voltage or reverse-polarity voltage as it
will cause serious damage to the system
.
6.2. Operating procedures
1. Attach the TX to the V-Mount on the camera or other video source
device and RX to the monitoring side with same manner. If either
device does not have a V-Mount, use an applicable adapter.
2. Connect the SDI output of camera and SDI input of TX with a BNC
cable. Then connect the SDI output of RX and SDI input of
monitoring or other devices with BNC cable.
TX has loop-through SDI output and RX has buffered SDI output
equipped for ease of use.
3. Attach the fully charged ENDURA batteries to TX and RX, or plug
in the 4P- XLR connector to EXT DC input.
Note: DC voltage will be supplied for both CW-7 and video
camera/monitors simultaneously.
4. Set the FREQ SELECT, POWER MODE, UNI/MULTI switches on
both TX and RX in appropriate position.
5. Turn the power switch ON the LED shows link initialization status.
Please Refer P.14 “CW-7 Link initialization”.