IDX CW-5 - Manual (Page 6)

‐4‐
CHAPTER 2 Getting Started
2.1 CW-5TX
1.POWER LED PowerON/OFF Status and colour:
⑨
⑩
④ ⑤ ⑧ ⑧
① ② ③ ⑥ ⑦
— Green light: Operating by battery
— Amber light : Operating by external DC-IN
— No light : Power is OFF
2.LINK LED Indicates link status with CW-5RX:
— Slow blinking : searching for receiver
— Fast blinking : Connection with RX is being processed
— Fully Lit : connection and authentication complete
3.RATE LED Indicates transmit speed:
— Fast blinking : high rate
— Medium blinking: middle rate
— Slow blinking : low rate
4.AUDIO IN Connect to the video camera audio output connector
Pin Assign
No1: GND No2:L CH IN（H） No3:L CH IN（C）
No4 :R CH IN（H） No5:R CH IN（C）
5.VIDEO IN Connect to the video camera video output connector
6.PAIRING SW Used for TX and RX Pairing setup
7.IR IR signal beam to setup Pairing
8.ANT Transmitting diversity antenna
9.POWER SW Power operation ON/OFF
10.DC-IN Connect when external power supply is used
Input range: DC11V～24V
Pin Assign No1：negative (-) No4：positive (+)