IDX CW-5 - Manual (Page 8)

‐6‐
CHAPTER 3 Operation Guide
3.1 Set up
The CW-5 dos not include the following, please prepare them before
use
.
● BNC cable for Video 2 or 3 cables
● XLR (5 pin) cable for audio 2 cables
* Please refer “ Chapter 2 Getting started “ for XLR connector
Pin assignments
● ENDURA series V-Mount batteries or external power supply
Note : External power supply
Use only an AC adaptor, or batteries with a DC output of 11V –
24V. The CW-5 DC-IN connector product number is
HR10A-7R-4PC（HIROSE.）Please refer “ Chapter 2 “ Getting
started “ for XLR connector Pin assignments.
3.2 Operating procedures
①
Mount antennas (included) to CW-5TX and CW-5RX antenna
connectors.
②
(Example of use) Connect CW-5TX to the battery mount of the
video camera, and CW-5RX to the monitor battery mount. If
either device does not have a V-Mount as standard use
applicable adapter.
③
Connect video camera video /audio output connector and
CW-5TX video/audio input connector cables. Also connect
monitor etc video/audio input connector and CW-5RX
video/audio output connector cables.
Please note that CW-5RX video output connector has two
outputs so it can be connected to two monitors simultaneously.
④
Connect a fully charged ENDURA battery to CW-5TX and CW-5RX
and turn the power on. (Power LED lights green.)
When external power supply is used, connect to DC-IN connector
and turn the power on.(Power LED lights Amber.)
Note:
When using an ENDURA battery, power is supplied to both CW-5
and video camera / monitors etc. However, when external power
supply is used power is only supplied to the CW-5, video camera,
monitors etc must be powered separately.