IDX CW-5 - Manual (Page 9)

‐7‐
3.3 When reception is unstable
Signal reception may be effected according to the position, height and
angle of placement. If reception is not stable, please look for the best
condition by adjusting the location and antenna angle/direction etc.
3.4 Back-up power failure function
When an external power supply is used power failure can be avoided
by mounting an ENDURA battery to CW-5 at the same time. if the
external power supply fails, use can continue via battery power.
Depending on conditions, video quality may be momentarily affected.
3.5 Power saving mode
When the CW-5 is used with ENDURA batteries, power supply to video
camera, monitor etc will not stop even when CW-5 power switch is
turned off.
While video camera or monitor is still operating the power supply on
CW-5 can be turned off, so saving battery consumption.
CHAPTER 4 Pairing
1. The CW-5 is already supplied paired (matched) from the factory.
2. If needed users can also pair manually using the following
steps (note if units are not paired correctly when operated
communication is not possible):
„
Supply power to and switch on both CW-5TX and CW-5RX
„ Bring TX and RX connector surfaces to approx. within 20cm
distance and face connectors toward each other.
„ Then press the pairing button at the top of the CW-5TX for at
least 2 sec.
Note: The CW-5TX sends an authorisation code to the CW-5RX
and when this configuration data is confirmed over the IR link
the pairing is set.