Sound Devices PIX 270i - Manual (Page 79)

PIX 270i User Guide and Technical Information
73
Se
tup Menu Op
tions
# Parameter Name Description Options
6 Input PsF Detect
When set to “Auto”, the PIX will sense PsF signal
based on a flag within the signal stream. Most devices
with SDI output will provide this flag, however some
SDI outputs and all HDMI outputs will not provide this
flag. When sending PsF signal from these devices,
choose “Interpret 1080i as PsF”
» Auto
• Interpret 1080i as PsF
7 SDI Output Type
HD output type employs SMPTE 292M / HD-SDI on
SDI output. 3G output type employs SMPTE 424M /
3G-SDI on SDI output.
» HD (4:2:2 10-bit)
• 3G (4:4:4 12-bit)
8 Video Output OSD
Superimpose the current timecode over the video sig-
nal on the selected output. Timecode value appears in
lower left corner of the frame.
» Off
• SDI out
• HDMI out
• SDI + HDMI out
Audio
# Parameter Name Description Options
1 Audio Mode Sample Rate The sample rate of recorded .wav files
• 44.1 kHz
• 47.952k
• 47.952kF
» 48k
• 48.048k
• 48.048kF
• 88.2k
• 96k
2 Audio Mode Bit Depth The bit depth of recorded .wav files
• 16-bits
» 24-bits
3 Audio Mode Pre-Roll Time
The amount of pre-record buffer for audio-only record-
ing. 0-10 seconds in 1 second increments.
» 2 secs
(numeric)
4 Input Gain Linking
When Input Gain is linked, adjusting an Input’s gain
adjusts all Input Gains by the same amount. Any
offsets at the time of linking are maintained.
» Off
• On
5 Input Delay Linking
When Input Delay is linked, adjusting an Input’s delay
adjusts all Input delays by the same amount. Any
offsets at the time of linking are maintained.
» Off
• On
6 HDMI/AES Select Choose between HDMI or AES for digital audio input.
» HDMI Inputs
• AES Inputs
7 MADI Input
Choose between BNC or Optical (SC) source for
MADI input signal.
» BNC
• Optical