Triton TDJ 600 - Manual (Page 6)

5
GB
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power
tool’s operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
Safety Instructions / Symbols
Additional Safety for Standard Drills
For safety relating to protective clothing/equipment and
general health hazards relating to power tools; refer to
General and Electrical Safety sections in this manual
• Important: It is imperative to follow all national safety
regulations concerning installation, operation and
maintenance
• Extension cable reels used with this tool must be com-
pletely unravelled. Minimum conductor cross section:
1.0mm2
• When using this tool outdoors, connect to a power sup-
ply with an RCD device and minimum 1.5mm2 exten-
sion cable with water protected plugs in good working
order
• Ensure that the drill bit is securely fixed in the chuck.
Insecure drill bits can be ejected from the machine
causing a hazard
• Always wait until the drill has come to a complete stop
before putting it down
SYMBOLS
ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.
Always wear ear, eye and respiratory
protection.
Do not use before viewing and
understanding the full operating
instructions
Conforms to relevant legislation
and safety standards.
Instruction warning.
Double insulated for additional
protection.
186171_29-11-12_Z1MANPRO1.indd 5 05/06/2013 10:41