Tweco 200 XT Auto-Cut 480V - Manual (Page 32)

AUTO-CUT 200 XT
3-8 INSTALLATION Manual 0-5286
3.07 Connect Work Cable
1. Refer to the illustration below. Pass the end of the work cable through the cord grip at the back of the power
supply rear panel, then through the bottom opening in the bulkhead panel.
2. Refer to the illustration below. Connect the lead to the bolt in the first hole on the bus bar as shown. Tighten
securely. Do not overtighten.
WARNINGS
Ensure that lead attachment hardware is properly sized. Excess length may cause damage if hardware contacts other
parts of the system.
Art # A11951