Tweco 300 XT Auto-Cut 380V - Manual (Page 60)

AUTO-CUT 300 XT
4-12 OPERATION Manual 0-5261
CCM Status Code
Group 6 -- CCM
Code Message Remedy / Comments
601 Analog Voltage Error Defective CCM, replace.
602 ADC or DAC error Defective CCM, replace.
603 Reserved No information available; Contact customer service
604 Data Memory error Defective CCM, replace.
605 Program memory fault Defective CCM, replace.
606 +5V Logic supply low Defective CCM, replace.
607
Processor over tem-
perature
Reduce ambient temperature; Defective CCM; replace
608
5V supply for RS
485/422 communica-
tion low.
Defective CCM, replace.
609
Firmware Update
Device Error
Defective CCM; replace
610
Firmware Update
Protocol Error
Defective CCM; replace
611 USB Controller Fault Defective CCM; replace
612 USB Power Fault Remove faulty USB device; Defective CCM
613 USB Log Creation Fault
Unable to create Log fi le on USB Flash drive last fi rmware update attempt; Use different USB
Flash Drive or Reformat
614 No USF File
File VTCCMFW.USF missing from Flash Drive; Add proper fi les to Flash Drive for Firmware
Update; Use different USB Flash Drive or Reformat
615 No CCM Update File
CCM Firmware fi le specifi ed in VTCCMFW.USF not found ; Add proper fi les to Flash Drive for
Firmware updating
616 DPC Update Fault
Fault occurred attempting to update DPC fi rmware; Add proper fi les to USB Flash drive for
Firmware updating; Refer to CCM_LOG.TXT on Flash Drive for details
617 DMC Update Fault
Fault occurred attempting to update DMC fi rmware; Add proper fi les to USB Flash drive for
Firmware updating; Refer to CCM_LOG.TXT on Flash Drive for details
618 ADC Calibration Fault Error too large calibrating ADC; Fault persists defective CCM;
619 Flow Switch Fault Flow switch reporting coolant fl ow when pump off;
620
Non Volatile Memory
Error
Non Volatile Memory Storage Corrupted and Erased; Fault persists defective CCM.