Ultra-cut 100 xt – Tweco 100 XT Ultra-Cut Plasma Cutting System User Manual
Page 43
Advertising
ULTRA-CUT 100 XT
Manual 0-5272
INSTALLATION
3-21
3. Insert the fiber-optic cable connector into the receptacle on the vertically-mounted circuit board as shown.
Cable must snap into place.
Circuit Board
Fiber Optic Cable
Art # A-04773
4. Tighten the through�hole protector for the fiber�optic cable using hand tools.
5. Reinstall the Cover Panel making sure the ground wire is attached.
Advertising