Ultra-cut 100 xt – Tweco 100 XT Ultra-Cut Plasma Cutting System User Manual
Page 48
Advertising
ULTRA-CUT 100 XT
3-2�
INSTALLATION
Manual 0-5272
2. Remove the Cover Panel from the Arc Starter.
Art # A-12059
Lower screws
(2 per side)
Upper screws (2 per side)
Cover
Ground Wire
Cover Removal
3. Position the Arc Starter on a flat, horizontal mounting surface.
4. Use pre�drilled holes in at least two of the feet on the bottom of the Arc Starter to secure the Arc Starter to
the mounting surface.
Art # A-12060
Minimum 2
Advertising