Ultra-cut 100 xt – Tweco 100 XT Ultra-Cut Plasma Cutting System User Manual
Page 52
Advertising
ULTRA-CUT 100 XT
3-30
INSTALLATION
Manual 0-5272
2. Reinstall the Arc Starter Cover. Ensure that the ground wire is not crimped between the cover and the base.
Art # A-12059
Lower screws
(2 per side)
Upper screws (2 per side)
Cover
Ground Wire
3. The Arc Starter must be grounded; the grounding terminal is marked . Refer to the previous section for
grounding details.
Ground Cable
Art # A-04758
1 Nut and 1 Washer
Remain in Place
Torch Leads
Advertising