Tweco 201 ts Thermal Arc - Manual (Page 13)

Manual 0-5149 2-1 Introduction
INTRODUCTION THERMAL ARC 201 TS
SECTION 2:
INTRODUCTION
2.01 How to Use This Manual
This Manual usually applies to the part numbers listed
on page i. To ensure safe operation, read the entire
manual, including the chapter on safety instructions
and warnings. Throughout this manual, the word
WARNING, CAUTION and NOTE may appear. Pay
particular attention to the information provided under
these headings. These special annotations are easily
recognized as follows:
!
WARNING
Gives information regarding possible per-
sonal injury. Warnings will be enclosed in
a box such as this.
CAUTION
Refers to possible equipment damage.
Cautions will be shown in bold type.
NOTE
Offers helpful information concerning
certain operating procedures. Notes will
be shown in italics
You will also notice icons from the safety section ap-
pearing throughout the manual. These are to advise
you of specific types of hazards or cautions related
to the portion of information that follows. Some
may have multiple hazards that apply and would look
something like this:
2.02 Equipment Identification
The unit’s identification number (specification or part
number), model, and serial number usually appear
on a nameplate attached to the machine. Equipment
which does not have a nameplate attached to the
machine is identified only by the specification or part
number printed on the shipping container. Record
these numbers for future reference.
2.03 Receipt of Equipment
When you receive the equipment, check it against
the invoice to make sure it is complete and inspect
the equipment for possible damage due to shipping.
If there is any damage, notify the carrier immediately
to file a claim. Furnish complete information concern-
ing damage claims or shipping errors to the location
in your area listed in the inside back cover of this
manual. Include all equipment identification numbers
as described above along with a full description of
the parts in error.
2.04 Transportation Methods
!
Disconnect input power
conductors from de-energized supply line before
moving the welding power source.
Lift unit with handle on top of case. Use handcart or
similar device of adequate capacity. If using a fork
lift vehicle, secure the unit on a proper skid before
transporting.