Tweco 201 ts Thermal Arc - Manual (Page 15)

Manual 0-5149 2-3 Introduction
INTRODUCTION THERMAL ARC 201 TS
2.06 Description
This compact inverter welding machine has infinitely
adjustable welding current from 10 to 200 amps.
The 201TS has a LIFT TIG (GTAW) and HF TIG
(GTAW) welding mode that offers stable TIG welding
characteristics with an optimized start TIG sequence
to initiate the welding arc when used with a suitable
TIG torch and shielding gas. Advanced TIG features
include 8 Pin Amp Plug for remote control devices,
down slope, 2T / 4T controls, and gas solenoid
operation. It also has STICK (MMA) welding mode
which uses standard general purpose STICK (MMA)
2.5mm (3/32”) electrodes for light gauge work,
generally less than 3.2mm (1/8”) thick and STICK
(MMA) 3.2mm (1/8”) electrodes for heavier material.
2.07 User Responsibility
This equipment will perform as per the information
contained herein when installed, operated, maintained
and repaired in accordance with the instructions pro-
vided. This equipment must be checked periodically.
Defective equipment (including welding leads) should
not be used. Parts that are broken, missing, plainly
worn, distorted or contaminated, should be replaced
immediately. Should such repairs or replacements
become necessary, it is recommended that such re-
pairs be carried out by appropriately qualified persons
approved by Thermal Arc. Advice in this regard can
be obtained by contacting an Accredited Thermal Arc
Distributor.
This equipment or any of its parts should not be al-
tered from standard specification without prior written
approval of Thermal Arc. The user of this equipment
shall have the sole responsibility for any malfunction
which results from improper use or unauthorized
modification from standard specification, faulty
maintenance, damage or improper repair by anyone
other than appropriately qualified persons approved
by Thermal Arc.