Tweco 300 S Arcmaster - Manual (Page 15)

ARCMASTER ® 300 S
March 31, 2006 2-1
SECTION 2:
INTRODUCTION AND DESCRIPTION
2.01 How To Use This Manual
This Owner’s Manual applies to just specifi cation or part
numbers listed on page i.
To ensure safe operation, read the entire manual, including
the chapter on safety instructions and warnings.
Throughout this manual, the words WARNING, CAUTION, and
NOTE may appear. Pay particular attention to the information
provided under these headings. These special annotations
are easily recognized as
follows:
!
WARNING
A WARNING gives information regarding possible
personal injury.
CAUTION
A CAUTION refers to possible equipment
damage.
NOTE
A NOTE offers helpful information concerning
certain operating procedures.
Additional copies of this manual may be purchased by
contacting Thermal Arc at the address and phone number in
your area listed in the inside back cover of this manual. Include
the Owner’s Manual number and equipment identifi cation
numbers.
Electronic copies of this manual can also be downloaded at
no charge in Acrobat PDF format by going to the
Thermal Arc web site listed below and clicking on the
Literature Library link:
http://www.thermalarc.com
2.02 Equipment Identifi cation
The unit’s identifi cation number (specifi cation or part number),
model, and serial number usually appear on a nameplate
attached to the control panel. In some cases, the nameplate
may be attached to the rear panel. Equipment which does
not have a control panel such as gun and cable assemblies is
identifi ed only by the specifi cation or part number printed on
the shipping container. Record these numbers on the bottom
of page i for future reference.
2.03 Receipt Of Equipment
When you receive the equipment, check it against the invoice
to make sure it is complete and inspect the equipment for
possible damage due to shipping. If there is any damage,
notify the carrier immediately to fi le a claim. Furnish complete
information concerning damage claims or shipping errors to
the location in your area listed in the inside back cover of
this manual.
Include all equipment identifi cation numbers as described
above along with a full description of the parts in error.
Move the equipment to the installation site before un-crating
the unit. Use care to avoid damaging the equipment when
using bars, hammers, etc., to un-crate the unit.