Tweco 2RT Transmig User Manual
Operating manual, Transmig, Wire feeder
Advertising
Table of contents
Document Outline
- SECTION 1: ARC WELDING SAFETY INSTRUCTIONS AND WARNINGS
- SECTION 2: INTRODUCTION
- SECTION 3: INSTALLATION OPERATION AND SETUP
- 3.01 Environment
- 3.02 Location
- 3.03 Ventilation
- 3.04 Mains Supply Voltage Requirements
- 3.05 Electromagnetic Compatibility
- 3.06 2RT Wire Feeder Controls, Indicators and Features
- 3.07 Transmig 250i Power Source Controls, Indicators and Features
- 3.08 Advanced Features Details
- 3.09 Wire Feeder Set Up MIG (GMAW) Welding with Gas Shielded MIG Wire
- 3.10 Wire Feeder Set-up for MIG (FCAW) Welding with Gasless MIG Wire
- 3.11 Attaching the Tweco Professional MIG Torch (Euro)
- 3.12 Installing a Handi Spool (200mm diameter)
- 3.13 Installing a Standard Spool (300mm diameter)
- 3.14 Inserting Wire into the Feed Mechanism
- 3.15 Feed Roller Pressure Adjustment
- 3.16 Feed Roller Alignment
- 3.17 Changing the Feed Roll
- 3.18 Input And Output Wire Guide Installation
- 3.19 Wire Reel Brake
- 3.20 Shielding Gas Regulator Operating Instructions
- SECTION 4: BASIC WELDING GUIDE
- SECTION 5: ROUTINE SERVICE REQUIREMENTS
- SECTION 6: KEY SPARE PARTS
- APPENDIX 1: Options and Accessories
- APPENDIX 2: 2RT WIRING SCHEMATIC
- CIGWELD LIMITED WARRANTY
- TERMS OF WARRANTY – APRIL 2010
- WARRANTY SCHEDULE – APRIL 2010
- GLOBAL CUSTOMER SERVICE CONTACT INFORMATION
- SECTION 1: ARC WELDING SAFETY INSTRUCTIONS AND WARNINGS
- CIGWELD LIMITED WARRANTY
- TERMS OF WARRANTY - APRIL 2010