Tweco 7-3443 - Manual (Page 3)

October 6, 2004 3 Manual 0-2771
10. Reinstall any covers removed (see WARNING).
WARNING
Make sure that the Control Connector Wires DO NOT contact the Adapter Fitting after all leads are connected.
11. Install the proper torch consumables for the Power Supply amperage.
12. Reconnect main input power to the Power Supply and turn the unit ON.
13. Set air pressure to 60 - 70 psi (4.1 - 4.8 bar).
14. Test the torch for proper operation.
This completes the replacement insructions.
NOTE
Every effort has been made to provide complete and accurate information in this manual. However,
the publisher does not assume and hereby disclaims any liability to any party for any loss or damage
caused by errors or omissions in this manual, whether such errors result from negligence, accident or
any other cause.