Tweco 9-8419 User Manual
Page 2
Date: January 28, 2002 2 Manual 0-2833
B. Long Trigger Guard Installation
Install the Long Trigger Guard as follows:
1. Remove the screw located at the bottom-front of the
Torch Handle. This screw can be discarded. Refer to
the illustration.
2. Remove the screw located at the bottom-back of the
Torch Handle. Set the screw aside as it will be rein-
stalled later.
3. Place the Trigger Guard onto the Torch Handle.
4. Secure the Trigger Guard to the right side of the Torch
Handle using the supplied 6-32 x 5/8" long screw (see
NOTE).
NOTE
This screw holds the Handle Halves together and
must be installed first.
5. Secure the Trigger Guard to the left side of the Torch
Handle using the supplied 6-32 x 1/4" long screw.
6. Secure the Trigger Guard to the right side of the Torch
Handle using the screw removed in step 3 above.
Right Side of
Torch Handle
Remove Lower
Screw Only
(Discard)
Remove And
Keep Lower
Screw
A-03232
Install 6-32 x 5/8"
Screw (Supplied)
Install 6-32 x 1/4"
Screw (Supplied)
Long Trigger
Guard
Use Original
Screw
Long Trigger Guard Installation
NOTE
Every effort has been made to provide com-
plete and accurate information in this manual.
However, the publisher does not assume and
hereby disclaims any liability to any party for
any loss or damage caused by errors or omis-
sions in this Manual, whether such errors re-
sult from negligence, accident, or any other
cause.