Tweco W4015101 - Manual

FABRICATOR 211i & 252i ROLL CAGE ASSEMBLY INSTRUCTIONS
February 3, 2012 1 0-5233
Manufacturer: Thermadyne Industries
Address: 82 Benning Street West Lebanon,
New Hampshire 03784 USA
Telephone: 1-800-426-1888 • Fax: 1-800-535-0557
Email: [email protected]
www.thermalarc.com
Manual 0-5233
Roll Cage Kit for Fabricator 211i
Part Number: W4015104
Roll Cage Kit for Fabricator 252i
Part Number: W4015101
Assembly Instructions
General Information
This document provides a guide for the assembly and installation of the Roll Cage Kit onto the Fabricator 211i/252i
power source. The Roll Cage protects the Fabricator power source case from collision damage plus doubles as a
sturdy hand lifting frame.
NOTE
The Roll Cage Kit is designed to fit the Fabricator 211i/252i power source without any modifications.
NOTE
Only the Roll Cage Kit or Welding Equipment Cart may be fitted to the Fabricator 211i/252i power
source at any one time.
!
WARNING
Do Not lift the Roll Cage / power supply via a crane or similar means. The Roll Cage / power supply
should only be lifted by hand.
For an Equipment Cart specifically designed for use with the Fabricator 211i or Fabricator 252i plus gas cylinder,
welding gun and various accessories, use Part No. W4015001.
Recommended Tools
12mm or 4mm Open Ended Wrench or 6” Adjustable Wrench
6mm Allen Wrench (Hex Key)
T25 Torx-Bit for power source case screw
Assembly Instructions
WARNING
Unplug the Fabricator power source unit before attaching the Roll Cage Kit.
NOTE
Use the following assembly procedure to attach the Roll Cage to the Power Source. It is difficult to
attach the Power Source to a fully assembled Roll Cage.
© 2012 by Thermadyne Industries