Tweco W4015101 - Manual (Page 4)

FABRICATOR 211i & 252i ROLL CAGE ASSEMBLY INSTRUCTIONS
February 3, 2012 4 0-5233
3. Fasten the assembled Roll Cage together, using the following hardware:
• Socket Cap Screw (Item 7)
• Saddle Washer (Item 8)
Saddle Washer
Socket Cap Screw
Art # A-11096
C. Install Handle to the Roll Cage
1. Remove the Screw from the top cover using the Torx-Bit T25. Keep this screw as it will be reinstalled later
in Step 5.
Specification of the Screw is M6 x 12mm.
Art # A-10604
Screw