Viking Pump TSM343.3: Vi-Corr Pumps - Manual

CONTENTS
INTRODUCTION
The illustrations used in this manual are for identification purposes only and cannot be used for
ordering parts. Obtain a parts list from the factory or a Viking® representative. Always give the
complete name of part, the part number and material along with the model number and serial
number of the pump when ordering repair parts. The pump model and serial number can be
found on the nameplate secured to the pump.
In the Viking model number system, model size numbers are combined with series numbers
with a suffix indicating mounted pump unit.
This manual deals only with Series RP composite pumps. Refer to Figures 1 through 9 for
general configuration and nomenclature used in this manual. Pump specifications and
recommendations are listed in Catalog Section 343.
UNMOUNTED PUMP
UNITS
LIP SEAL MECH. SEAL
RP-0782 RP-40782
Units are designated by the unmounted pump model
numbers followed by a letter indicating drive style.
D = Direct Drive
M = Motor Mounted (Close Coupled C-Flange)
R = Viking Reducer Drive
P = Commercial Reducer Drive
M4 = Motor Mounted (Close Coupled Four-Bolt)
RP-0716 RP-40716
RP-0724 RP-40724
RP-0732 RP-40732
I ntroduction 1
Special Information 2
Installation & Start Up 3
General Pump Disassembly 6
RP-07 Series (Lip Seal) 9
Disassembly & Assemby
RP-407 Series (Mechanical Seal) 11
Disassembly & Assembly
Troubleshooting
15
Do’s and Don’ts 17 FIgURE 1
SERIES RP-07 PUMP
TECHNICAL
SERVICE MANUAL
SECTION TSM
PAGE
ISSUE
343.3
1 OF 20
F
Electronic copies of the most current TSM issue can be found on the Viking Pump website at www.vikingpump.com
VIKING PUMP, INC.
•
A Unit of IDEX Corporation
•
Cedar Falls, IA 50613 USA
INSTALLATION, START UP, TROUBLESHOOTINg,
PREvENTIvE MAINTENANCE, DO’S & DON’TS
vI-CORR® COMPOSITE PUMPS SERIES RP-07 & RP-407