Viking Pump TSM443: K-LL 4205-G LP Gas - Manual

SECTION TSM 443
PAGE
1 Of 8
ISSUE C
VIKING PUMP, INC. • A Unit of IDEX Corporation •
Cedar Falls, IA 50613 USA
TECHNICAL SERVICE MANUAL
INTRODUCTION
Introduction 1
Safety Information 2
Special Information 3
Maintenance 3
Disassembly 5
Assembly 6
Thrust Bearing Adjustment 6
Pressure Relief Valve Instructions 6
Warranty 10
UNMOUNTED
PUMPS UNITS
K200-G Units are designated by the
unmounted pump model numbers
followed by a letter(s) indicating
drive style
V = V-Belt
D = Direct Drive
R = Viking Speed Reducer
P = Commercial Speed Reducer
KK200-G
KK260-G
L200-G
LQ200-G
LL200-G
MODEl NUMBER ChaRT
This manual deals exclusively with the 200-G and 260-G
series bracket-mounted LP-Gas pumps Refer to figures
1-13 for general configuration and nomenclature used in this
manual
CONTENTS
The illustrations used in this manual are for identification
purposes only and should not be used for ordering parts
Secure a parts list from the factory or a Viking® representative
Always give complete name of part, part number and material
with model number and serial number of the pump when
ordering repair parts
The unmounted pump or pump unit model number and serial
number can be found on a nameplate attached to the pump
or base
CaUTION !
ThE 200-G aND 260-G SERIES aRE Ul
lISTED PUMPS. aNY ChaNGES OR
REPaIRS TO ThE PUMP WIll VOID ThE Ul
lISTING. TO MaINTaIN ThE Ul lISTING,
ThE PUMP WIll NEED TO BE REPlaCED
WITh a NEW PUMP OR REPaIRED aND
RETESTED aT ThE FaCTORY.
SPECIal INFORMaTION
DaNGER !
Before opening any Viking pump liquid
chamber (pumping chamber, reservoir, relief
valve adjusting cap fitting etc.) Be sure:
1. That any pressure in the chamber has
been completely vented through the
suction or discharge lines or other
appropriate openings or connections.
2. That the driving means (motor, turbine,
engine, etc.) has been “locked out” or
made non- operational so that it cannot
be started while work is being done on
pump.
3. That you know what liquid the pump
has been handling and the precautions
necessary to safely handle the liquid.
Obtain a material safety data sheet
(MSDS) for the liquid to be sure these
precautions are understood.
Failure to follow above listed precautionary
measures may result in serious injury or
death.
FIGURE 1
200-G, 260-G SERIES
UNMOUNTED PUMP
VIKING BRaCKET MOUNTED lP-GaS PUMPS
SERIES 200-G aND 260-G
SIZES K, KK, l, lQ, ll
Electronic copies of the most current TSM issue can be found on the Viking Pump website at www.vikingpump.com