Viking Pump TSM442: GG-AL 4195-G LP-Gas - Manual

SECTION TSM 442
PAGE
1 Of 10
ISSUE C
VIKING PUMP, INC. • A Unit of IDEX Corporation •
Cedar Falls, IA 50613 USA
TECHNICAL SERVICE MANUAL
INTRODUCTION
Introduction 1
Safety Information 2
Special Information 3
Maintenance 3
Disassembly 5
Assembly 6
Thrust Bearing Adjustment 6
Pressure Relief Valve Instructions 6
Supplementary Section 8
Warranty 10
UNMOUNTED
PUMPS UNITS
GG 4195-G
Units are designated by the
unmounted pump model numbers
followed by a letter(s) indicating
drive style
D = Direct Drive
HJ 4195-G
HL 4195-G
AS 4195-G
AK 4195-G
AL 4195-G
fIgURE 1 - gg, HJ, HL 4195-g UNMOUNTED PUMP
MODEL NUMbER CHaRT
This manual deals exclusively with the 4195-G Series LP-Gas
pumps Refer to figures 1 thru 10 for general configuration
and nomenclature used in this manual
CONTENTS
The illustrations used in this manual are for identification
purposes only and should not be used for ordering parts
Secure a parts list from the factory or a Viking® representative
Always give complete name of part, part number and material
with model number and serial number of the pump when
ordering repair parts
The unmounted pump or pump unit model number and serial
number can be found on a nameplate attached to the pump
or base
CaUTION !
The 4195-g series is a UL listed pump. any
changes or repairs to the pump will void
the UL listing. To maintain the UL listing,
the pump will need to be replaced with a
new pump or repaired and retested at the
factory.
If the UL listing is no longer required, refer
to TSM 144 for repair instructions. These
can be obtained from your authorized
Viking Pump distributor.
fIgURE 2 - aS, ak, aL 4195-g UNMOUNTED PUMP
Electronic copies of the most current TSM issue can be found on the Viking Pump website at www.vikingpump.com
VIkINg LP-gaS PUMPS
SERIES 4195-g
SIZES gg - aL