Great Plains 3P606NT Assembly Instructions - Manual (Page 14)

Great Plains Mfg., Inc.
14 Small Seeds Option
133-140M 04/02/2009
Install Seed Delivery Hardware
Refer to Figure 20
63. Select one new per row:
123-939H SMALL SEEDS TUBE WELDMENT
and two per row:
801-002C SCREW HEX SLT10-16X1/2P.THD CT
Insert a seed tube in the open hole directly ahead of
the T-handle adjustment slot
, in each opener
frame. The seed tube may be pointed forward or
back. Great Plains recommends angling the bent
lower tube to face to the rear.
Secure each seed tube to each opener with the self-
tapping screws.
Seed Hose Installation
Refer to Figure 21
64. Start with row 1 (left-most row), and work to the
right, one row at a time, to assure correctly connect-
ing each meter to its assigned row (row units are not
necessarily directly below their meters).
65. Select one per row:
816-513C SGS HOSE 85 RIBS
and two per row:
800-321C HOSE CLAMP NO.12 3/4 ID
Slide one clamp onto each end of the hose, about
2in (5cm) from the end of the hose.
Slide one end of the hose fully onto the meter
outlet . The end of the hose should touch the con-
ical section of the meter.
Squeeze the clamp to release it, and slide the
clamp to about
1 ⁄
4
in (6mm) from the end of the hose
(or about the same distance above the end of the
outlet). Release the clamp.
Slide the lower end of the hose fully over the
exposed top of the small seeds delivery tube
.
Squeeze the clamp to release it, and slide the
clamp to about
1 ⁄
2
in (13mm) from the end of the
hose (halfway between the bump and the flange).
Release the clamp.
66. If the drill is not equipped with Native Grass, con-
tinue at step 69 on page 15.
Figure 20
Seed Tube Installation
18721
13
1
27
13
27
1
Figure 21
Seed Hose Installation
18721
26
2
41
26
13
41
26
41
2
13