Great Plains 3P606NT Assembly Instructions - Manual (Page 3)

Great Plains Mfg., Inc.
Installation Instructions 3
04/02/2009 133-140M
Work Location
5. Move the drill to a location with:
• room to maneuver large parts around it,
• access to tractor or hydraulic power,
• adequate illumination, and;
• clear surface beneath for recovery of any falling
or dropped parts - if the surface is not clear, have
a tarp or drop cloth available.
6. Park the drill per the instructions in the Operator
Manual.
7. Lower the drill and the openers
8. Shut off tractor if left hitched.
Remove Existing Parts
Refer to Figure 3
9.
At each grab handle on the back corners of the rear-
most seed box, remove and save two sets (four sets
total) of:
802-203C HFSS 1/2-13X1 1/2 GR5
803-169C NUT HEX FLG. LOCK 1/2-13 PLT.
and two:
119-190D HANDLE
These are re-mounted on the new SGS box at
step 15 on page 4.
Note: Existing hardware may vary slightly from parts
called out in these instructions. For example,
instead of flange nuts, there may be separate
washers and there may be a 133-045D strap. Note
such changes, so that parts are correctly re-
installed.
Refer to Figure 4
Step 10 is required only for drills with existing Native
Grass boxes, but is recommended for all drills, to clear
access for mounting the SGS box.
10. At the SMV placard remove and save two sets:
802-007C HHCS 5/16-18X3/4 GR5
804-009C WASHER LOCK SPRING 5/16 PLT
803-008C NUT HEX 5/16-18 PLT
and then remove the still-assembled SMV
890-153C SMV MOUNTING BLADE
WARNING !
Negative tongue weight hazard:
Lower the openers on pull-type drills. The weight of a person
on raised openers can cause an unhitched tongue to fly up,
causing a fall and possible serious injury.
Figure 3
Dismount Grab Handle
18651
88
92
81
U
D
B
F
R
L
88
92
81
Figure 4
Dismount SMV
18565
89
85
93
96
85
93
89
96