Great Plains 3P606NT Assembly Instructions - Manual (Page 6)

Great Plains Mfg., Inc.
6 Small Seeds Option
133-140M 04/02/2009
Install SGS Drive
Install 3P500/3P600 Drive Components
Install 3P500/3P600 Shaft Bearings
For 3P605NT, 3P606NT, 605NT or 606NT, skip to
“Install 3P/605/606NT Drive Components” on page 10.
Refer to Figure 9
21. Select two (2) new:
822-040C BRG INS .75IDX1.85OD SPH LCK
four new:
822-041C FLANGETTE 47 MST
and four sets new:
802-282C RHSNB 5/16-18X1 GR5
804-036C WASHER FLAT 5/16 SAE PLT
804-009C WASHER LOCK SPRING 5/16 PLT
803-008C NUT HEX 5/16-18 PLT
Place each bearing between two flangettes .
As necessary, back out set screws in lock collars so
that bearings can slide freely on shaft. Bearing lock
collars (not shown) are oriented to drill center
(inside). Mount each flangette on the forward bear-
ing opening on the outside of the end panels.
Insert a bolt through the flangettes and the
panel. Add a flat washer , then a lock washer ,
and secure to finger-tight with nut .
Figure 9
Install 3P500/600 Bearings
18655
29
43
44
44
U
D
F
B
L
R
37
34
30
43
44
29
37
34
30
43 44
29
37 34
30