Great Plains 4000TT Predelivery Manual - Manual (Page 16)

12 1200-4000TT Great Plains Manufacturing, Inc.
586-201Q 02/11/2014
4000 Hydraulic Wing Lift & Fold Assembly
Refer to Figure 9
Note: The hydraulic hoses are all attached to center
frame and rolled up for wings.See hydraulic layout
drawings in “Appendix” for complete hose routing.
38. Un-roll the hoses and route them along wing frame
as shown.
39. Hook the hose that is fastened to rod end of cylinder
to base end of wing cylinder.
40. Attach longer hose from tee on center frame to the
rod end of wing cylinder.
41. Fasten front fold hose from tee to base end of outer
fold cylinder.
42. Attach other front fold hose from rod end of inner fold
cylinder to rod end of outer fold cylinder.
43. Fasten back fold hose from rear tee to base end of
outer fold cylinder.
44. Fasten hoses to wing frame with bolts and clamps
(provided) on hitch frame.Attach hose wraps on
hoses to prevent hoses from dragging or getting
pinched.
45. See “Attach Hose Clamps and Hose wraps” on
page 14 for proper assembly.