Great Plains 4000TT Predelivery Manual - Manual (Page 20)

16 1200-4000TT Great Plains Manufacturing, Inc.
586-201Q 02/11/2014
Light Bracket and SMV Assembly
Note: The light brackets will be shipped in right location,
but u-bolts will need to be removed and brackets
will need turned to correct position.
Refer to Figure 13
54. Install light bracket assemblies
(models 2400 &
3000) with 1/28 x 3 1/32 x 4 u-bolts , 1/2 lock
washers and 1/2 nuts, place in proper location, 3”
below bottom of wing stop tube and top edge of plate
of light bracket.
55. Install light bracket assemblies (model 4000), with
1/28 x 3 1/32 x 4 u-bolts , 1/2 lock washers and 1/2
nuts, place in proper location, 8” from outside of ver-
tical tube to inside edge of mounting plate of light
bracket.
Refer to Figure 14
56. Install light bracket assemblies (model 1800) on
outside, rear of center frame between gang bar tube
and torque tube bracket with 1/2 x 3 1/32 x 6 u-bolts
, 1/2 lock washers and 1/2 nuts, bottom side of
frame tube.
57. Mount light bracket assemblies (model 1500)
same way as model 1800, only on top side of frame
tube,
Note: When the lights are mounted, be sure all plugs are
attached on the wiring harness.
58. Attach smv assembly (models 1200 & 1500) with
1/2 x 5 x 5 1/2 u-bolts , 1/2 lock washers and 1/2
nuts.
59. Mount smv sign (models 1800-4000) to plate on
wing stop with 1/4 x 3/4 pan head screws , lock
washers and 1/4 nuts.
60. Tighten all bolts to specs, See “Torque Values
Chart” on page 23.
1
2
1
2
3
4
5
6
7
8
9
Figure 13
Lights 41075
1
2
1
2