Great Plains 3N-3020P Operator Manual - Manual (Page 62)

3N-3010P and 3N-3020P
196-248M 4/23/2010
60
Opener Maintenance
20 Series Opener Side Wheels
Refer to Figure 59
1. Lift opener side wheel off the ground. Move
tire in and out to check for end play. Check for
roughness in bearing by rotating wheel. If the
bearings are rough, inspect and replace if
necessary.
2. Check for the correct number of flat washers
(1) and machine washer (8) between the side
gauge wheel (2) and the wheel arm (3). There
must be three flat washers (1) and one ma-
chine washer (8) between the wheel bearing
and arm with the machine washer (8) next to
the arm. There should be three flat washers
(1) and one lock washer (9) on the outside of
the wheel. When installed, the wheel should
turn freely and not hit the arm at the curve. Do
not add any more washers than necessary.
3. Disassemble side-gauge-wheel arm from
unit. Remove bushing (4) from sleeve (5) and
check bushing for wear. Replace bushing if
necessary.
4. When reinstalling side gauge wheels, align
tab on hex adjustment (6) with notch in bush-
ing. Replace bolt and tighten.
5. To prevent plugging loosen clamp bolt (7) and
slide arm inward to take up gap between side
wheel and disk blade.
6. Adjust side gauge wheels. Refer to “Adjust-
ments,” page 36.
Opener Disks
Refer to Figure 60
1. On 20 Series openers, remove side gauge
wheel arm and wheel assembly by removing
5/8 inch bolt (4) to access opener disks and
spreaders.
2. Check disk blades for wear.
3. When reinstalling disk blades, put two shims
(4) between bearing and shank on one blade
and two shims under bolt. Tighten bolt. On
opposite side, reinstall blade with two shims
between bearing and shank and two shims
under bolt. Tighten bolt.
4. Check contact point between disk blades.
Place a piece of paper in top gap between
disk blades. Bring paper down until it stops. In
lower gap place another piece of paper. Bring
20432
1/2 inch to
1 3/4 inches
18412
Figure 59
Figure 60