Marker maintenance, Storage – Great Plains 3N-3020P Operator Manual User Manual

Page 65

Advertising
background image

4/23/2010

196-248M

63

Maintenance and Lubrication

17621

Figure 64

Marker Maintenance

Refer to Figure 64

The marker arm is attached to marker body with a
3/8-inch, grade 2, shear bolt. If this shear bolt
breaks, replace it with a grade 2 bolt.

Note: Failure to replace the shear bolt with a
grade 2 bolt can cause marker damage.

If grease-seal cap for marker-disk-hub bearings is
damaged or missing, disassemble and clean hub.
Repack with grease and install a new seal or
grease cap.

Storage

Store the drill where children do not play. If possi-
ble, store the drill inside for longer life.

1.

Unload seed box:

Place tarp under drill or a bucket under each

seed meter.

Use a large bucket to empty box as much as

possible. Make sure sliding seed tubes are in
the open position. Open seed meter clean out
to empty seed out of sliding seed tube and
meter.

2.

Thoroughly clean seed and seed-treatment
residue from boxes and seed meters.

3.

Remove seed meter wheels. Store flat and
out of the weather.

4.

Remove any dirt and debris that can hold
moisture and cause corrosion.

5.

Lubricate and adjust all roller chains.

6.

Lubricate areas noted under “Lubrication”,
page 64.

7.

Inspect drill for worn or damaged parts. Make
repairs and service during the off season.

8.

Use spray paint to cover scratches, chips and
worn areas on the drill to protect the metal.

9.

Cover with a trap if stored outside.

Advertising
This manual is related to the following products: