Area total / implement width – Great Plains V-300F Operator Manual User Manual
Page 51
6/29/2006
148-057M
49
Monitor Operation
Area Total / Implement Width
The area is derived from the forward speed and the programmed
implement width and is accumulated to whichever total is selected
on the display – total 1 or total 2.
Area will only accumulate while the drill is in work, i.e. forward
speed is being registered.
The two separate area totals can be independently reset to zero.
Display Area Total
1.
Select the
channel.
2.
Press
to cycle between the two area totals.
The display will then show ‘tot.1’ or ‘tot.2’ before displaying the
area accumulated since that total was last reset.
Reset Totals
1.
Select the
channel.
2.
Press
to cycle between the two area totals.
3.
Hold
for 5 seconds to zero that total.
2
3
Display Area Total
Select Total 1 or Total 2
Reset Total