Great Plains 2420P Assembly Instructions - Manual (Page 6)

120-299M 4/8/2004
Great Plains Mfg., Inc.
Veris Drive Option 6
Refer to Figure 11
17. Install the console in a convenient location on
a side window glass. Make sure the glass is
clean. Moisten cups and press firmly onto the
glass. To remove, pull tab on suction cup.
18. Connect power port adaptor cable to the ter-
minal on the console.
19. Route the power and communication cables
through the cab access hole and connect to
the appropriate terminals on the console.
Refer to Figure 12
A gauge wheel brake has been added to keep the
gauge wheel from “free wheeling” when the drill is
raised causing the Veris Drive to operate.
1. With the drill hooked to the tractor, raise the
drill. Make sure the tractor is on level ground.
Place tractor in park, turn off ignition and re-
move the key.
2. Working at the left-hand gauge wheel, make
sure the gauge wheel is in its full down posi-
tion. Position gauge wheel brake (1) on the in-
side of gauge wheel frame at the hole (2)
indicated. Assemble brake to the frame using
a 1/2” x 1 3/4” bolt, 1/2” flat washer, 1/2” lock
washer and 1/2” nut.
3. Adjust the brake so it rest firmly against the
gauge wheel tire and tighten bolt.
Figure 11
Controller Console
19977
Figure 12
Gauge Wheel Brake
19978