Great Plains 3000TM Assembly Manual - Manual (Page 39)

Great Plains Manufacturing, Inc. Assembly 35
11/12/2013 586-536Q-ENG
Install Rear Hitch (optional)
Note: Carefully un-band the components. There are two dif-
ferent types of rear hitches, rear hitch extended or a-
frame style. See appropriate mounting directions listed
below.
Extended Rear Hitch
Refer to Figure 32
136.Attach middle of rear hitch arms
to rear tube of drag
frame with 5/8 x 3 1/32 x 4 1/2 u-bolts , 5/8 lock wash-
ers and 5/8 nuts. Attach front plates of rear hitch arms
to rear tube of center frame with 3/4 x 5 1/32 x 4 1/2 u-
bolts
, 3/4 lock washers and 3/4 nuts.
137.Attach 46” cross arm to bottom side of rear hitch truss
plates with 5/8 x 3 1/32 x 4 1/2 u-bolts , secure with 5/8
lock washers and 5/8 nuts.
Note: Do not tighten any bolts until every thing is installed.
138.The bolt on sleeve assembly with rigid or flex slide
may be fastened using 5/8 x 3 1/32 x 4 1/2 u-bolt ,
secure with 5/8 lock washers and 5/8 nuts.
139.If machine is equipped with rolling harrow only, attach
rigid or flex slide to rear tube of drag frame, with 5/8 x
3 1/32 x 4 1/2 u-bolts , secure with 5/8 lock washers
and 5/8 nut.
140. Tighten all bolts to specs, See “Torque Values Chart”
on page 38.
A-Frame Hitch
Refer to Figure 33
141.Attach rear mounting bar
to rear of center frame with
3/4 x 2 bolts , 3/4 lock washers and 3/4 nuts.
142.Attach a-frame hitch to rear of center frame with 5/8 x
4 1/32 x 4 1/4 u-bolts , 5/8 lock washers and 5/8 nuts.
143.Hitch will have either the flex slide assembly or the
rigid slide assembly . There will be a 3/4 x 1 1/2 hex
bolt and 3/4 jam nut in front hole of assembly to keep
the slide assembly from sliding clear out.
144.If machine is equipped with optional rear hitch accessory
kit, it may be installed as shown in “Parts Manual”.
145. Tighten all bolts to specs, See “Torque Values Chart”
on page 38.
146.Route hoses and light harness along hitch and frame
with hose clamps and hose wraps, provided.
Note: Be sure hoses and light harness are fastened securely
so they don’t drag or get pinched.
2
3
1
Figure 32
Extended Rear Hitch
42076
4
7
5
2
6
1
2
1
3
4
2
5 6
2
7
2
5
4
3
Figure 33
A-Frame Hitch
42441
2
7
6
1
1
2
3
4
5
6
7