Great Plains NTA3007HD Operator Manual - Manual (Page 2)

2 Great Plains Manufacturing, Inc. Front Page Part Lists Contact Drive Update
166-367M Front Page Part Lists 02/21/2012
Pre-Assembly Preparation
Tools Required
• cutting torch
• wire or rod welder, and welding safety equipment,
including a fire extinguisher
• ground (earthing) rod, cable and clamp (or access to
suitable electrical safety ground reference conductor)
• suitable tractor for raising and unfolding air drill
• Great Plains 821-001C spray paint, or green exterior
enamel close to Pantone 356C, DuPont 262 or
PPG 43817
• basic hand tools
Work Location
1. Move the air drill to a location with:
Prepare Air Drill
2. Raise implement with tractor.
3. Unfold implement.
4. Install lift and transport locks.
5. Disconnect all harnesses to tractor.
6. Connect a grounding cable from the center section
main frame to earth ground
• flat, non-combustible surface free of flammable
materials
• adequate illumination
• clear surface beneath for recovery of any falling or
dropped parts
Burn and Fire Hazards:
This update requires cutting and welding thick metal. Perform
the work clear of flammable materials. Wear suitable protec-
tive equipment. Allow hot parts to cool before continuing
work.
Crushing and Sharp Object Hazards:
Be careful working near openers. Discs and other parts may
be sharp.
Equipment Damage Risk:
Disconnect harnesses and ground frame before welding.
Connected harnesses or ungrounded frame during welding
can result in permanent damage to seed monitor components.