Great Plains 4000-3S Assembly Instructions - Manual (Page 5)

2/17/2005 195-252M
Great Plains Mfg., Inc.
5 Installation Instructions
Figure 7
17088
Figure 8
17089
12. Using the existing tee fittings, connect 72"
hoses from the pressure control valve in the
center (21) to center section cylinders.
IMPORTANT: Connect hoses from rear port in
the pressure-control valves to the base end of
cylinders. Connect hoses from bottom port in
pressure-control valves to rod end of cylinders.
Refer to Figure 8
10. Using two elbow fittings, connect 72" hoses
from the pressure-control valve on the far left
(19) to left wing cylinders.
11. Using two more elbow fittings, connect 72"
hoses for pressure-control valve on the far
right to right wing cylinders (20).
Refer to Figure 7
9. At the drill frame, remove the tee fittings (18)
in the wing hydraulic circuit.