Great Plains 6324DV Operator Manual - Manual (Page 17)

Great Plains Mfg., Inc. Table of Contents ►
Section 1: Assembly
6/10/2004 Series VII 5110-6324 Discovator 550-220M
15
Wing and Wheel Arm Assembly
Bolt the wing frames (1) Figure 2, to the
center frame with two 1 x 6 hex bolts (2) with
nylon lock nuts (3). Draw the nuts down tight
but do not torque.
Once the wings are attached, insert the
wheel arm bracket (4) into the wing frame
hangers and secure it just as you did on the
center with 1 1/4 x 6 pins (5). Secure the pins
with 3/8 x 2 1/4 Gr.8 hex bolts (6) & lock nuts.
Install the wing transport or walking
beam assembly (7) as shown in Figure 2. (see
parts manual for parts differences). Use anti-
seize material on the spindles. Secure the
spindles in the sleeve with the 5/16 x 3 clevis
pin (8) and 1/8 x 1 cotter.
Bolt the 9.5L x 15, 8-ply tire (9) in
place with the 1/2 x 1 1/4 lug bolts (10), or 1/2”
lug nuts for heavy hub option.
Figure 2
11/22/2004