Great Plains 6324DV Operator Manual - Manual (Page 18)

Section 1: Assembly
Table of Contents ► Great Plains Mfg., Inc.
Series VII 5110-6324 Discovator 550-220M 6/10/2004
16
Brace Bar, Wing Brace & Rocker Bracket Assembly
On 3-section models, install the 1 x 7
1/2 eye bolt (1) Figure 3, in the mounting
bracket at the back of the wing with a 1” jam
nut on each side of the bracket. Install the 3
3/4 x 8 rephasing wing cylinder (2) and 3 1/2 x
8 wing cylinder (3) between the eyebolt and the
lever on the wheel bracket. Secure the
cylinders with 1 x 3 clevis pins, 1” machine
washer and 3/16 x 2 cotter pins.
Bolt the center brace bar (4) and wing
brace bars, on 3-section models, (5) to the front
of the center frame and wing frame with 3/4 x 2
hex bolts (6) with lock washers and hex nuts.
Do not tighten bolts. Use a 1 x 6 hex bolt (7)
and nylon lock nut in the hinge. Draw nut tight
but do not torque. Tighten all other bolts
evenly to prevent bind at hinge.
On 3-section models, Bolt the center
fold bracket (8) to the center frame with four
3/4 x 5 hex bolts (9) with lock washer and hex
nuts. Bolt the rocker brackets (10) to the wings
using four 3/4 x 5 hex bolts (11) with lock
washers and hex nuts. On model 6324, u-bolt
the tie strap bracket (12) to the wing frame with
two 1/2 x 3 x 5 u-bolts (13) with lock washers
and hex nuts. Bolt the 53 3/4 connecting link
(14) between the rocker bracket (10) and the tie
strap bracket (12) with two 1 x 3 hex bolts (15)
using 1” hex lock nuts.
Figure 3
2/02/2005