Great Plains 6324DV Operator Manual User Manual
Page 2
Great Plains Mfg., Inc.
Table of Contents
2/12/2009
Series VII 5110-6324 Discovator 550-220M
Table of Contents
Important Safety Information .......................... 1
Safety Rules................................................... 6
Safety Decals ................................................ 7
Introduction ........................................................ 12
Definitions.............................................. 12
Owner Assistance .......................................... 12
Assembly and Setup Assistance .................... 13
Section 1 Assembly ............................................. 14
Center Frame, Torque Tube & Transport
Assembly ................................................. 14
Wing and Wheel Arm Assembly .................. 15
Brace Bar, Wing Brace & Rocker
Bracket Assembly .................................... 16
Center Gang & Gang Hanger Assembly. ...... 17
Center Truss, Hitch and Strut Assembly ...... 18
Hitch Tongue, Side Plate and Level Bar
Assembly ................................................. 19
Center Lift Cylinder, Rest Pads and
Hydraulic Valves Assembly .................... 20
Fold Cylinders & Rocker Arm Assembly .... 21
Center Wing Stop Assembly ........................ 22
Completing Setup ......................................... 23
Section 2 Hydraulics .......................................... 24
Typical Lift Hose Layout .............................. 24
Typical Fold Hose Layout............................. 25
Section 3 Machine Layout ................................. 26
5110D Machine Layout, Disc ...................... 26
5315D Machine Layout, Disc ...................... 27
6112D Machine Layout, Disc ...................... 28
6318D Machine Layout, Disc ...................... 29
6320D Machine Layout, Disc ...................... 30
6324D Machine Layout, Disc ...................... 31
5110C Machine Layout, Coulter .................. 32
5315C Machine Layout, Coulter .................. 33
6112C Machine Layout, Coulter .................. 34
6318C Machine Layout, Coulter .................. 35
6320C Machine Layout, Coulter .................. 36
6324C Machine Layout, Coulter .................. 37
Disc Gang Identification .............................. 38
Coulter Gang Identification .......................... 39
Section 5 Operating and Maintenance.............. 40
Prior to Going to the Field ........................... 40
First Time Machine Setup and Adjustments 40
General Operating Instructions and
In-Field Adjustments ............................... 42
Maintenance and Lubrication ....................... 44
Section 6 Specification and Capacities ............. 45
Appendix ............................................................. 46
Torque Values for Common Bolt Sizes ....... 46
Tire Inflation Chart ...................................... 46
Warranty ....................................................... 47
©
Copyright 2004 All rights Reserved
Great Plains Manufacturing, Inc. provides this publication “as is” without warranty of any kind, either expressed or implied. While every precaution has been taken in the
preparation of this manual, Great Plains Manufacturing, Inc. assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from
the use of the information contained herein. Great Plains Manufacturing, Inc. reserves the right to revise and improve its products as it sees fit. This publication describes
the state of this product at the time of its publication, and may not reflect the product in the future.
Great Plains Manufacturing, Incorporated Trademarks
The following are trademarks of Great Plains Mfg., Inc.: Application Systems, Ausherman, Land Pride, Great Plains
All other brands and product names are trademarks or registered trademarks of their respective holders.
Printed in the United States of America.