Great Plains 4000TM Predelivery Manual - Manual (Page 36)

32 1200-4000TM Table of Contents Index Great Plains Manufacturing, Inc.
586-288Q Table of Contents Index 11/06/2012
Reel Following Rolling Harrow (optional)
Note: It is very important to install the reel assembly in
the order shown below and go to the rolling harrow
placement drawing, see “Layout Section” of this
manual for proper dimensions where it is marked
xxx in drawing below. The reel arm assemblies
dimensions are coming off of rear tube of drag
frame to side of plate of reel arm assemblies .
The reel assemblies are dimensioned off of end
of reel assembly tube to side of plate on reel
arm assembly (dimensions in layout drawings
may come off either end of tube). For complete
parts breakdown see “Attachment Section” of
Parts Manual.
Refer to Figure 37
127.Install mounting reel arm assemblies
in position
shown in reel following rolling harrow placement
drawing with 5/8 x 3 1/32 x 4 1/2 u-bolts
, 5/8 lock
washers and 5/8 nuts. Torque u-bolts to 150ft-lb.
128.Attach reel tube with 5/8 x 2 17/32 x 3 1/2 u-bolts
, secure with 5/8 lock washers and 5/8 nuts.
Torque u-bolts to 150ft-lb.
129.Attach reel assemblies in direction shown in circle
and place them in position shown (with arrow
towards machine) with 5/8 x 2 17/32 x 3 1/2 u-bolts
, secure with 5/8 lock washers and 5/8 nuts.
Torque u-bolts to 150ft-lb.
130. Check to see that all bolts have been tightened to
specs, See “Torque Values Chart” on page 36.
1
1
5
3
1
1
2
3
4
5
4
3
4
1
Figure 37
Reel Following Rolling Harrow 42275
2
5
4