Great Plains 8-10m Press Range SN 12672+ Operator Manual - Manual (Page 17)

17 8-10m Press Range
Operating Instructions
2. Transportation / Installation
2.5.2 Folding into the
Transport Position
1. Firstly remove all excess soil and debris
from the machine.
2. If it has not already been done, turn off
the inline hydraulic tap on the catcher
line (yellow).
3. Raise the transport wheels fully by
extending the wheel cylinders (blue) to
full stroke! This must be done to
avoid any damage to the machine.
4. Turn off the power source to the solenoid
valve (the machine comes with this
wired into the side light function on the
light cable). This must be done to allow
oil flow out of the tilt cylinders.
5. With the wheel unit fully raised operate
the tilt cylinder (red) circuit to fold the
machine forward. Continue to pump until
the spine touches the stops on the
drawbar.
6. With the wings now vertical, checking
the taps on the catcher line is closed,
operate the wing (yellow) circuit to close
the wings around the drawbar.
7. With the wings closed around the
drawbar open the tap on the catcher
line.
8. With the catcher inline tap open continue
to operate the wing (yellow) circuit to lift
the catchers and take the load of the
machine.
9. Turn off the inline tap to lock the catchers
up, fold the light units up and make one
final check around the machine.
10. The press is now ready for road
transport.
Unfolding
Continued
E
F
G