Great Plains 3N-3020 Material Rate User Manual
Page 10
Advertising
196-366B
4/28/2004
Great Plains Mfg., Inc.
10
Refer to Figure 14
Enter drill width here using the Up/Down arrow
keys. Press FUNCTION key to advance to next
window.
Refer to Figure 15
Enter the number of rows here using the Up/Down
arrow keys. Press FUNCTION key to advance to
next window.
Refer to Figure 16
Enter your planned planting speed using Up/
Down arrow keys. Calibration mode will not ac-
cept a speed higher than 10 mph. Press
FUNCTION key to advance to next window.
Figure 14
Enter Drill Width
Figure 15
Enter Number of Rows
Figure 16
Enter Planting Speed
Advertising
This manual is related to the following products: