Great Plains 3N-3020 Material Rate - Manual (Page 14)

196-366B 4/28/2004
Great Plains Mfg., Inc.
14
Refer to Figure 26
If you wish to keep the Old number, perhaps to re-
run the calibration procedure, press the Down ar-
row key. If you want to accept the New calibration
number, press the Up arrow key.
Refer to Figure 27
Console window now displays the calibration
number you have selected. This returns you back
to the beginning of Calibration mode as shown in
Figure 28. To re-run the Calibration procedure, fol-
low the steps outlined above. It is suggested that
you perform the calibration at least twice, and ad-
ditional replications may be needed if Target and
Actual amounts vary significantly.
Figure 26
Figure 27
Figure 28
Calibration Mode