Changing double sprocket, Changing jackshaft sprocket – Great Plains 3PNG15 Material Rate User Manual
Page 13
Great Plains Manufacturing, Inc.
Smalls Seeds Box Planting
11
12/01/2010
202-579B
Changing Double Sprocket
Loosen idlers
and
, and remove both chains
from double sprocket
5.
Remove retaining pin
6.
Remove sprocket
from shaft, and reverse orienta-
tion of which disk is in/out.
7.
Replace sprocket
8.
Place chains back on sprockets.
9.
Re-engage idler and tighten, leaving
3
⁄
4
in slack in for-
ward span of chain
10. If jackshaft sprocket does not need to be changed,
Changing Jackshaft Sprocket
It may be necessary to shorten or lengthen the upper
chain. It has removable links for this purpose.
Refer to Figure 3
When re-assembling a chain, make sure the open end of
the clip faces away from the direction of chain travel, to
reduce chain fouling from debris caught in the clip.
Refer to Figure 11
11. If the double sprocket did not need to be changed,
loosen upper idler (
12. Remove chain from jackshaft sprocket
13. Loosen set screws
on both upper sprockets (only
one of two shown in figure).
14. Slide current sprocket aside. Position it so that is
does not rub on any fixed machine parts. Re-tighten
the set screw.
15. Slide new sprocket into approximate position.
16. Re-mount chain, and align sprocket
so that chain
is perpendicular to the jackshaft (parallel to the
ground drive frame). Tighten set screw
17. Re-engage idler
1
⁄
2
in
slack in the forward span.
1
Figure 9
Double Sprocket
16409
4
5
3
6
1
5
6
Figure 10
Chain Link and Clip
26482
Figure 11
Jackshaft Sprockets
16412
2
8
7
2
7