Great Plains Smartbox Mount Kit Yield Pro Planters - Manual (Page 11)

Great Plains Mfg., Inc.
Installation Instructions 11
12/12/2006 403-206M
Mount Left Inner-Most YP1225/1625 Smartbox
Refer to Figure 17 and Figure 20
25. Select:
one
➀
Smartbox frame,
two (18) 403-319D,
(SMART BOX HOLD DOWN CLAMP),
two (27) 802-223C,
(HHCS 3/8-16X4 GR5),
two (26) 802-079C,
(HHCS 3/8-16X1 1/4 GR5), and
four (31) 803-209C,
(NUT FLANGE LOCK 3/8-16 PLT).
If the base container is already installed on the
SmartBox frame, it may be necessary to remove it
to gain access to the mounting holes.
26. Insert a 1
1 ⁄
4
in bolt (26) in the forward slotted
mounting hole
➁
on one side of the frame
➀
. Slip
the shorter end of a clamp (18) over the bolt (26)
and add a flange lock nut (31). Put only a few turns
on the nut.
27. Position the frame
➀
about 4in from the end of the
inner-most end of the new tube
➂
, or directly next
to the air pipe support plate.
28. Insert a 4in bolt (27) in the slotted hole
➃
just for-
ward of center on each side of the frame
➀
, and
then down through the hole in the clamp (18), and
add a flange lock nut (31). Put only a few turns on
the nut.
29. Alternately tighten the lock nuts (31), keeping the
Smartbox frame
➀
and the base of the clamp (18)
parallel to the tube
➂
top and bottom, and the front
of the clamp snug against the front of the tube.
30. Repeat Step 26 through Step 29 for the other side
of the frame
➀
.
31. Position Smartbox base container/meter or
container/splitter/meter assembly
➄
in the frame
➀
, having the meter ports biased to the Right, and
secure with fasteners provided by AMVAC.
Mount Right Inner-Most YP1225/1625 Smartbox
32. Repeat Step 25 through Step 31 for the innermost
Smartbox on the right side of the machine, using a
Smartbox base container/meter or container/
splitter/meter assembly with the meter exit port(s)
biased to the Left.
Figure 17
Near-Pivot Mounting
25329
➀
18
27
31
26
U
D
B
F
R
L
➂ 18
➁
➃
Figure 18
YP1225/1625 Inner-Most
24176
➁
26
31
➃
18
➂ 31
26
➀
➄